SkyTrak 3606 Service Manual - Manual (Page 107)

Cab, Covers and Mirrors
4-21
Keep the mirrors clean for optimal operator performance.
Replace any mirror with cracked glass as vehicle use and
vibration will eventually, if not immediately, cause the
crack(s) to worsen or the mirror glass to fall out.
The mirror mounted on the left side of the cab (item 6,
Fig. 4–36) and the hood-mounted mirror head (1) are
attached to mirror arm assemblies. These mirror heads
can be replaced independently of the arm and mounting
hardware.
The mirror assembly (item 11, Fig. 4–36) and mirror
assembly arms (2 and 7) are secured to the vehicle with
screws (3, 8 and 9) and washers (4, 5 and 10). Removal
and installation are easily accomplished by observing the
mounting configurations illustrated in Fig. 4–36.
4.2.10 Cab Panel Replacement
The cab is equipped with various panels, as shown in
Fig. 4–37 and in the General Overview illustration on
page three. Removal and installation are easily accom-
plished by observing the mounting configurations as
shown in the illustrations.
4.3 CAB COVERS AND GUARDS
4.3.1 Cover and Guard Replacement
The vehicle is equipped with various covers and guards
(Fig. 4–37). Removal and installation are easily accom-
plished by observing the mounting configurations as
shown in the illustration.
4.3.2 Engine Hood
Engine Hood Removal
1. Park the vehicle on a firm, level surface. Allow
sufficient overhead clearance for engine hood
removal. Level the vehicle, ground the attachment,
place the travel select lever in NEUTRAL (N), engage
the parking brake switch and shut the engine OFF.
Open the engine hood. Allow the engine and
hydraulic fluid to cool.
Note: If performing this procedure outside where blow-
ing wind is a factor, control hood movement at all times.
Wind can cause the hood to move unexpectedly.
2. Unlock and raise the hood (item 1, Fig. 4–37).
3. Support the hood in a suitable manner. Disconnect
the top spring clip (11) from the gas spring (15).
Reattach the spring clip to the gas spring and lower
the gas spring down out of the way. It is not
necessary to detach the lower spring clip or to
remove the gas spring.
4. Remove the cotter pins (18) and washers (4) from the
clevis pins (19). Remove the clevis pins.
5. With the help of at least one assistant, carefully lift
and remove the cover.
6. Store the cover securely to help prevent damage.
WARNING: Risk of severe personal injury.
Contact with hot engine or other components
will cause burns. Allow engine and components
to cool completely before proceeding. Failure to
comply will result in personal injury.
Model 3606 • Origin 10/99