SkyTrak 3606 Service Manual - Manual (Page 393)

Electrical System
10-75 Model 3606 • Origin 10/99
c. Steering Select Switch Removal
1. Disconnect the negative (-) battery cable at the
negative battery terminal (Fig. 10– 92).
Figure 10– 92. The negative (-) battery terminal.
1. Carefully pry the switch (Fig. 10– 93) and wiring out of
the mounting hole in the switch bezel.
Figure 10– 93. Steering select switch.
2. Label and disconnect the wiring from the switch. Note
and mark the "front" or top of the switch in relation to
the switch wiring terminals, and remove the switch
from the vehicle.
d. Steering Select Switch Disassembly,
Inspection and Replacement
DO NOT disassemble the switch. Replace a defective or
faulty switch with a new one. Inspect the switch and the
wiring harness connector terminals for continuity and
shorting in all three switch positions. Inspect the switch
terminals for continuity in the "up" and "down" positions
and for shorting in the "middle" position. Replace a
defective or faulty switch with a new one.
e. Steering Select Switch Installation and Testing
1. Route the wiring through the dash and switch bezel,
then connect the wiring (Fig. 10– 94) to the switch as
labeled during switch removal (the eight-pin
connector only goes on one way).
2. Properly position the “front” and top of the switch as
noted during removal, then press or “snap” the switch
into place in the bezel.
Figure 10– 94. Steering select switch wiring
and installation position.
3. Connect the negative (-) battery cable to its battery
terminal (Fig. 10– 92).
4. Clear the area around the vehicle of personnel and
any obstructions to vehicle travel.
5. Start the engine, and check the operation of the
steering select switch functions with the switch in all
three positions.
OS1040
Negative (-)
Terminal
OS1411
STEERING
SELECTION
INDICATORS
FOUR
WHEEL
STEERING
FRONT
WHEEL
STEERING
CRAB
STEERING
STEERING
SELECT
SWITCH
Steering
Modes
Steering
Select
Switch
display panel symbol
Steering Select Switch
Set for Front Wheel Steering;
see owners/operators manual
for explanation of operation/functions
18A GRY / GRN
18 GRY / GRN
17 PNK / WHT
19 YEL / BLK
19A YEL / BLK
2F BLK 53 DK BLU / ORG
NOTE: 18 and 18A, plus 19 and 19A
are double-terminated.
MS2490
Top of Switch
Top of Switch