Mueller Snap Lock (MSL) - Manual (Page 17)

17
FIXED EAVE
Installation Steps: (use only with floating ridge/hip)
1. Install eave trim onto the eave strut using #10 x 1 self drill pan head screws, 3 per 10’.
2. Apply butyl tape sealant to top leg of the eave trim as shown.
3. Install panel and screw to the eave strut using #12 x 1¼ self drill screws. Panel should overhang the eave
trim by 1¼” to accommodate optional gutter.
4. Seal the ends of the panel legs using tube sealant.
NOTE: Blanket insulation omitted for clarity
RPN Wall Sheets
Eave Strut
Mueller Snap
Lock Sheet
#14 x 7/8" Lap
Tek Screw
(for Eave Trim Only)
Eave Trim
Purlin
Sealant #10 X 1" Pan Head
Self Drilling Screw
Clip
#12 X 1 1/4" Self Drill
Tek Screw with Washer
or Equivalent
2
3
4
1
Optional
Gutter