JB Conversions 2307 LoMax 300 - Manual (Page 8)

14) Reposition the case in the vertical press and remove the rear output shaft
from the helical Gear/roller bearing (Fig. 13).
Fig.13
15) Disassemble the input gear assembly beginning with the removal of the
retaining ring (Fig. 14).
Fig.14
16) Position the input gear assembly in a vertical press and push the input gear
out of the ball bearing (Fig. 15). The seal may be forced out of the housing
as the input shaft is pressed out. Discard the seal. Retain the shims
located between the input gear shoulder and ball bearing.
Fig.15