Apple Color StyleWriter Pro - Manual (Page 21)

4 Load a stack of U.S. Letter or A4 paper into the sheet feeder.
Installing your printer software
The Color StyleWriter Pro comes with a number of disks that contain the
printer software and a program called the Installer that copies the software
onto your hard disk. Follow these steps to install the software.
Before you begin Lock all the disks by turning each one over and sliding the
small, square plastic tab so you can see through the hole. (The disks may
already be locked.) If you have virus protection software, turn it off.
1 Insert the Color StyleWriter Pro Installation disk into a floppy disk drive.
The disk’s icon appears on the desktop, as shown in the next step.
2 Double-click the disk icon to see what’s on the disk.
Pull here if you want to open the output tray.
Be sure to pull it out all the way.
Slide this guide so it just touches the edge
of the paper. If the stack of paper bows out
even slightly, the guide is too tight.
Extend this paper support
Do not stack paper above this
line ( ).
Make sure the paper selector
is next to the (
∂ ) icon.
Make sure the paper lines up
evenly at this side of the feeder.
14 Chapter 1