Apple WaveBurner 1.6 - Manual (Page 13)

Track start markers are displayed as purple flags and index markers are shown as orange
flags in the Marker bars above and below the Region lanes.
Vertical Waveform Zoom
control
Horizontal Zoom control
Position line
Time ruler
Marker bar
Marker bar
Edit Tool buttons
Marker buttons Transport buttons
Region lanes
Mix lane
Auto Rendering button
Scroll bar
The Wave View area contains the following elements:
• Marker bars: You add, remove, and position markers in the Marker bars, located at the
top and bottom of the Wave View area. See Working with Markers .
• Time rulers: These show time units, enabling you to precisely place regions and
transitions at specific locations. Right-click (or Control-click) any ruler to open a shortcut
menu that enables you to change the ruler time format. You can also access this menu
by clicking the Arrow icon at the right end of the Zoom slider. If you enable the CD
Track Time menu item, the time rulers will display the track time (rather than the overall
disc time).
• Region lanes: Display regions. This is where you cut, move, and trim regions and adjust
region levels. See Working with Regions and Working with Tracks . You can also create
and edit effect parameter automation data in the Region lanes. See Automating Region
Effect Parameters .
• Position line: Shows the current playback position. See Moving the Position Line .
• Mix lane: The Mix lane is primarily designed for creating and editing automation data
for mix effect plug-ins. When the Auto Rendering button is enabled the Mix lane displays
the waveform results of edits performed in the Region lanes. The waveform also updates
to reflect changes caused by effects and automation. See
Automating Mix Effect
Parameters . Clipped signals are shown in red in the Mix lane. Use of markers that do
not conform to the Red Book standard are displayed as they will actually appear on
the CD in the Mix lane.
13 Chapter 1 Getting to Know WaveBurner’s Interface