Apple WaveBurner 1.6 - Manual (Page 37)

Reordering and Moving Regions
Regions are displayed in their order of appearance in the project—from top to bottom
in the Regions list, and from left to right in the Wave View area. You can reorder regions
in the Regions list.
To reorder region positions
µ
Vertically drag the region icon in the left column of the Regions list.
To move a region to a new time position
µ
Drag the region to the left or right in the Wave View area. This also moves the region’s
markers and all subsequent regions.
To move a region without affecting following region positions
µ
Hold Option before selecting and dragging the region. All subsequent region positions
are unchanged. The gaps at the beginning and end of the region being moved are
changed accordingly.
When you drag a region to the right, the pause length (the duration between the track
start marker and its pause start point) increases. When you drag a region to the left so
that it overlaps the previous region, the pause length is set to zero, and fades are
automatically added to the moved region (fade in) and the previous region (fade out),
thus creating a crossfade in the overlapped area.
You can adjust crossfade lengths and curves. For information about adjusting crossfades,
see
Adding and Adjusting Fades .
Note: The track start marker behavior outlined above only works when you have not
manually edited the track start marker (see
Automatic Positioning of Track Start Markers ).
Trimming Regions
You can trim (shorten) a region by adjusting either (or both) the start and end points.
To trim the start or end point of a region
1 Move the pointer over the left or right edge of the region.
37 Chapter 3 Working with Regions