Apple WaveBurner 1.6 - Manual (Page 33)

The zoom control slider uses a graduated scale. Moving the slider left, or clicking the left
side of the scale, zooms in for a closer view of a section of the Wave View area. Moving
the slider right, or clicking the right side of the scale, zooms out for a wider view. You can
also zoom in or out with menu commands, by using the Zoom tools in the toolbar, by
dragging the Zoom Scroll buttons, or by vertically dragging inside the Overview rectangle.
To zoom in
Do one of the following:
µ
Drag the Zoom slider left.
µ
Click the left part of the Zoom control.
µ
Choose View > Zoom In (or press the Down Arrow key).
µ
Click the Zoom In button on the toolbar.
µ
Drag downward on the red rectangle in the Overview.
µ
Minimize the scroll bar by dragging the Zoom Scroll buttons at either end. Shift-drag to
the right on a Zoom Scroll button to zoom in from the left or right side of a waveform.
Note that this is a horizontal zoom of the waveform, rather than a zoom of the left and
right channels of a stereo waveform.
µ
Move the mouse wheel down.
Note: You can also choose View > Maximum Zoom In (or press Option–Control–Down
Arrow) to set the display to the highest possible zoom level.
To zoom out
Do one of the following:
µ
Drag the Zoom slider right.
µ
Click the right part of the Zoom control.
µ
Choose View > Zoom Out (or press the Up Arrow key).
µ
Click the Zoom Out button on the toolbar.
µ
Drag upward on the red rectangle in the Overview.
µ
Minimize the scroll bar by dragging the Zoom Scroll buttons at either end. Shift-drag to
the left on a Zoom Scroll button to zoom out from the left or right side of a waveform.
Note that this is a horizontal zoom of the waveform, rather than a zoom of the left and
right channels of a stereo waveform.
µ
Move the mouse wheel up.
Note: You can also choose View > Maximum Zoom Out (or press Option–Control–Up
Arrow) to show as much of your project as possible in the Wave View area.
Note: Enable WaveBurner > Preferences > General > Zoom To Position Line to ensure
that the position line remains centered in the Wave View area when zooming.
33 Chapter 2 Getting Started with WaveBurner