Apple Xserve (Early 2008) DIY Procedure for Logic Board - Manual (Page 18)

Xserve (Late 2006/Early 2008) Logic Board Replacement Instructions 18
Xserve (Early 2008): Packing the Used Logic Board
Important: This packing procedure applies only to Xserve (Early 2008) logic boards. When
packing the logic board, place the board in an antistatic bag and set it component-side up in the
return box so that the raised areas on the board fit correctly between the foam supports on the
box. Don’t bend or flex the logic board.
Holding the board at the long sides, place it in the antistatic bag. 1.
Note that foam supports are glued to the top of the box, as shown. 2.