Apple Xserve (Early 2008) DIY Procedure for Logic Board User Manual
Page 28
Advertising
Xserve (Late 2006/Early 2008) Logic Board Replacement Instructions
28
Tighten the five Phillips screws that fasten the airflow duct to the fan array, in the order
3.
shown, to prevent the duct from warping. Do not overtighten the screws.
Replacing the FB-DIMMs
Important: Be sure to install each FB-DIMM in the slot on the replacement board that is
equivalent to the slot you removed it from on the original logic board.
Align the first FB-DIMM with its slot and press down until the latches snap back up into
1.
place.
Note: The FB-DIMM is designed to fit into the slot only one way. Be sure to align the notch in
the FB-DIMM with the small rib inside the slot.
Repeat for the remaining FB-DIMMs.
2.
Advertising