Apple Xserve (Early 2008) DIY Procedure for Logic Board - Manual (Page 22)

Xserve (Late 2006/Early 2008) Logic Board Replacement Instructions 22
Replacing the Processors
Unsnap the protective plastic cover from the first processor holder on the replacement logic 1.
board, unclip the holder latch, and open the holder.
Plastic protective cover
Holder latch Processor holder
Using a syringe of thermal grease, apply the entire contents of the syringe (approximately 4.5 2.
cc) to the top surface of the processor.
Important: Be sure not to get grease anywhere on the processor other than the very top, flat
surface that directly contacts the heat sink.