Lukas SC 557 - Manual (Page 26)

26
8. Assembly of the new blades is carried out in reverse order.
Detail I
REMARK:
Tighten the fi t bolt H during
assembly with a torque of
M
A
= 40 Nm!
Detail II
M
M
REMARK:
When assembling the pivot bolt,
ensure that it is fi xed with the roll
pins M as shown in detail II, and
that it is prevented from twisting.
REMARK:
Should the adhesion between the
Nord-Lock washer and the nut
become undone, they can still be
used.
However, during assembly, always
ensure that the serration of the
nut and the Nord-Lock washer are
positioned on top of each other
(see detail III).
Detail III
Säge-
verzahnung
CAUTION!
Don’t forget to apply LUKAS special grease to all sliding surfaces.
L
H