Lukas AHP 2-1E-632 - Manual (Page 14)

14 COD. 193555075 - v.2 - UPD 220207
33333 - SAFETY - SAFETY - SAFETY - SAFETY - SAFETY
Observe all the following safety rules. They are of the maximum importance for your own safety and the safety of others. In addition to
the indications in this chapter, observe also the prescriptions in all other sections of the manual.
DO NOT TAMPER WITH THE PROTECTIONS AND SAFETY DEVICES AND DO NOT MODIFY THE PUMP IN ANY WAY TO AVOID
CREATING POTENTIALLY HAZARDOUS SITUATIONS FOR WHICH THE OPERATOR OR SERVICE TECHNICIAN IS
UNPREPARED.
REMOVING OR TAMPERING WITH ANY OF THE SAFETY DEVICES ON THE PUMP AUTOMATICALLY INVALIDATES THE
WARRANTY AND ABSOLVES THE MANUFACTURER FROM ALL LIABILITY.
l The pump and the machine on which the pump is installed must be used exclusively by people over 18 years of age who have read
this manual and have a thorough knowledge of the machine and the pump.
l The pump may be used by persons over the age of 16 provided they are supervised by an adult.
l The work area must be kept clear of obstructions so that the pump can be operated in safe conditions.
Pay attention to falling objects which could strike the pump treadle and set the pump into operation.
l The work area must be kept clean and the floor must bear no traces of oil, grease and slippery or corrosive substances of any type.
l Keep the pump well clear of heat sources, naked flames and sparks. Maximum operating temperature of the pump is 50° C.
l Work clothes must be close fitting and buttoned up. Wear the protective clothing stipulated in the place where the pump is installed.
l Do not attempt to operate the pump by standing on the treadle, use only light foot pressure to operate the pump mechanism.
l Do not disconnect the air supply hose or the hydraulic oil hose until you are sure that the circuits are not pressurized.
l When connecting the pump follow the prescriptions in chapter 5 “Installation and start-up” and always use certified hoses and
couplings.
l If the pump develops a fault, do not attempt to repair it unassisted. Disconnect the compressed air supply, switch off the machine
to which the pump is connected and call the maintenance technician.
l Do not arbitrarily move the pump to different locations. The pump must be used in the position designated by the manufacturer of
the machine to which it is connected.