JUN-AIR JVac Dental Vacuum Suction System User Manual
Page 7
7
© 2012, JUN-AIR
We reserve the right to make any alterations which may be due to any technical improvements
Printed in the USA
JUN-AIR Dental Vacuum Suction System User Guide
CI-100A (Rev B)
UNPACKING
1. Examine contents for damage prior to removing
shipping carton.
a. If shipping damage is found, immediately
contact the freight carrier to file a claim.
2. Carefully remove the shipping carton from the
pallet containing the vacuum system.
3. Visually inspect the entire vacuum system for
shipping damage.
a. If shipping damage is found, immediately
contact the freight carrier and supplier.
4. Verify that the installation kit parts were shipped
with the system:
a. Installation kit parts shipped with all vacuum
system models include the following:
• (3) Hose barbs
• (6) Hose clamps
• (3) Low pressure intake hoses (37.5
inches in length)
• (1) O&M Manual
5. Remove the installation kit parts and set aside
until the unit is ready to be installed.
6. Remove the (8) 5/16 in carriage bolts and the
four shipping brackets from the sound enclosure.
7. Remove the (3) 5/16 in carriage bolts from the
tank support frame.
8. Remove the band strap from tank.
Protective foam
3 x 5/16 in
carriage bolts
8 x 5/16 in
carriage bolts
4 x shipping
brackets
37.5"
Hose Clamp
Hose Barb
Hose
WARNING: DO NOT install on
surfaces with more than a 5° incline.
WARNING: Fasten unit to shipping pallet
prior to transporting the equipment to
prevent tipping or drainage.