Synergy 4040 - Synergy Sit Shower Shave Kit User Manual
Page 10
![background image](/manuals/549161/10/background.png)
remove a small coupler piece of 5/8” coolant hose and replace it with 2 longer pieces which will connect
to the heat exchanger.
We will begin by accessing the coolant lines at the front of the motor. It is easiest to do
this by removing the air intake.
Disconnect the 4 air box retaining clips as if you were replacing the air filter.
Next, remove the crankcase breather tube which connects to the air box (Yellow arrow in
picture 12.1 below)
Remove the two 10mm bolts which secure the intake tube to the radiator. (Red Arrows
in picture 12.1 below)
Loosen up the hose clamp at the throttle body and disconnect the electrical connection to
the intake temp sensor on the underside of the intake tube. (Blue Arrow in picture 12.1
below)
Picture 12.1