Synergy 4040 - Synergy Sit Shower Shave Kit - Manual (Page 20)

22) With the shower kit hooked up as shown above, the final step before use is to prime the system. The
pump will self prime and eliminate all air from the system using the following steps.
Fill the 5 gallon bucket with water from the water source you will be pulling from and
bring it next to the pump.
Place the strainer filter into the bucket.
Turn the shower head to the on position.
Turn the water pump on.
Water will begin to flow and you will see air bubbles get pulled through the hose. Re-
circulate the water until a steady stream of water is achieved.
Once a steady stream of water is coming out of the shower head, walk the bucket down to
your water source (creek, river, lake, etc.) and transfer the strainer filter from the bucket
to the water source without exposing it to air. The pump is now bled and will easily draw
water 40 ft vertically to the shower head.
SHOWER OPERATION NOTES
1. The operation temperature of the shower will vary depending on the efficiency of the vehicle’s cooling
system and the initial temperature of the water source which you will be pulling from.
2. The heat exchanger included in this kit is designed to work well when pulling from approximately 50
deg F water and ran through a vehicle which runs between 195 and 210 degrees F.