Synergy 5221-A - 2011+ Jeep JK 2/4 Door Front Cage Kit - Manual (Page 10)

19. With the A-pillar floor plates and cage tie-ins mocked into position, we will begin
fitting the A-pillars behind the dash.
20. We will start by removing a few key components of the dash to allow for easier
trimming to fit the A-pillars.
21. We will start by removing the sun visor, upper windshield trim, and lower windshield
trim.
The sun visors are secured with 2 small screws that can be
removed with a T20 torx bit. See image 21.1
Next, remove the small plastic screw and barb fitting in location 6
in image 21.2 below. Pull the upper trim down as there is a plastic
barb fitting which secures it to the roll cage.
Lastly, pull the lower A-pillar trim towards the back of the Jeep to
dislodge the clip from the windshield frame. See image 21.3
below.