Synergy 5221-A - 2011+ Jeep JK 2/4 Door Front Cage Kit User Manual
Page 46
59. If desired, add tube clamps at this time for dash bar removal (Part Number: 3113-150-
125). Be sure dash bar is level with the dash and tack into place once satisfied with
fitment. **Note** paint on A-pillar will need to be removed in this area for a clean
weld.
Note, if tube clamps are not being used on dash bar, paint the
majority of the dash bar prior to tacking into place as this will
make painting much easier. Just leave the ends of the dash bar
bare to allow for welding.
60. At this time, fully weld A-pillars, and dash bar. It is helpful to flip the windshield
down for welding. Just be sure to cover the dash and windshield during welding to
prevent damage from weld splatter.
61. Fit the A-pillar grab handles as desired and fully weld in place as well. These are
designed in a universal style so the installer can tailor fitment to their personal tastes.