Snorkel AB62RT - Manual (Page 6)

6
Elevating the Upper Boom
1. Set the function speed control dial to the desired
setting. Rotate the dial clockwise to increase speed,
counterclockwise to decrease. If you are not sure what
speed to use, start out slow; the speed can be varied
while operating the function.
2. While depressing the foot switch, push the upper boom
control lever forward to elevate the upper boom, rearward
to lower the upper boom. Release the control lever to
stop elevating / lowering.
Extending the Upper
Boom
1. Set the function speed control dial to the desired
setting. Rotate the dial clockwise to increase speed,
counterclockwise to decrease. If you are not sure what
speed to use, start out slow; the speed can be varied
while operating the function.
2. While depressing the foot switch, push the boom
extension control lever rearward to extend the boom,
forward to retract the boom. Release the control lever
to stop extending / retracting.
Elevating the Jib
1. Set the function speed control dial to the desired
setting. Rotate the dial clockwise to increase speed,
counterclockwise to decrease. If you are not sure what
speed to use, start out slow; the speed can be varied
while operating the function.
2. While depressing the foot switch, push the jib control
lever forward to elevate the jib, rearward to lower the jib.
Release the control lever to stop elevating / lowering.
Rotating the Platform
1. Set the function speed control dial to the desired
setting. Rotate the dial clockwise to increase speed,
counterclockwise to decrease. If you are not sure what
speed to use, start out slow; the speed can be varied
while operating the function.
2. While depressing the foot switch, push the platform
rotation control lever right to go counterclockwise and
left to go clockwise. Release the lever to stop rotation.
Leveling the Platform
DO NOT operate the machine if the platform
does not maintain level when elevated.
Note: Platform leveling can be performed only with
the boom stowed and should be done only to
calibrate the automatic leveling system.
1. Set the function speed control dial to the desired
setting. Rotate the dial clockwise to increase speed,
counterclockwise to decrease. If you are not sure what
speed to use, start out slow; the speed can be varied
while operating the function.
2. While depressing the foot switch, push the platform
level control switch forward to swing the platform
upward, rearward to swing the platform downward.
Release the switch to stop leveling.
Rotating the Turret
1. Set the function speed control dial to the desired
setting. Rotate the dial clockwise to increase speed,
counterclockwise to decrease. If you are not sure what
speed to use, start out slow; the speed can be varied
while operating the function.
2. While depressing the foot switch, push the turret
rotation control lever right to rotate counterclockwise,
left to rotate clockwise. Release the switch to stop
rotation. Observe the area around the boom when
rotating the turret to avoid any obstructions.
Elevating the Riser
1. Set the function speed control dial to the desired
setting. Rotate the dial clockwise to increase speed,
counterclockwise to decrease.
2. While depressing the foot switch, push the riser
control lever forward to elevate the riser, rearward to
lower the riser. Release the control lever to stop
elevating / lowering.
THIS MACHINE IS
NOT INSULATED.
This machine is not insulated. Follow
your national safety standards and
maintain the required safety distance
when working near
energized equipment.