Snorkel PUSH 10 PRO-sn01-000050+ANSI - Manual (Page 37)

33
Chapter 10 – Stowing and Transporting
To prevent unauthorized use and damage, properly stow
the aerial platform at the end of each work day. It must
also be properly stowed while transporting.
Stowing
Use the following procedure to properly stow the aerial
platform.
1. Fully lower the platform.
2. Push the emergency stop button in on the lower
control panel.
3. Turn the Control Selector switch off and remove Key.
4. Securely close the tray.
Transporting
The aerial platform may be moved on a transport vehicle.
Depending on the particular situation, the aerial platform
may be lifted with a forklift, winched, or hoisted onto a
vehicle such as a truck or trailer. Lifting with a forklift is
the preferred method.
The equipment used to load, unload, and transport the
aerial platform must have adequate capacity. The empty
vehicle weight is listed in Chapter 2 and is stamped on
the serial number placard.
The user assumes all responsibility for:
y
Choosing the proper method of transportation.
y
Choosing the proper selection and use of transporta-
tion and tie-down devices.
y
Making sure the equipment used is capable of sup-
porting the weight of the aerial platform.
y
Making sure all manufacturer’s instructions and warn-
ings, regulations and safety rules of their employer,
the DOT, and/or any other state or federal law are
followed.
Lifting With a Forklift
Use the following procedure to lift the aerial platform with
a forklift.
1. Properly stow the aerial platform.
2. Engage the brakes on both of the rear wheels.
3. Remove all personnel, tools, materials, or other loose
objects from the platform.
4. Insert the forklift forks into the pockets on either
side of the machine.(refer to Figure 10.1).
Figure 10.1 – Right Side of Chassis
Caution
Lifting the aerial platform with the forklift forks
positioned improperly can produce enough force
to damage machine components. When lifting the
machine with a forklift, only use the designated lift
points.
5. Do not raise the aerial platform higher than necessary
to transport it. Drive the forklift slowly and carefully
when transporting the aerial platform.
Winching
Use the following procedure to winch the aerial platform
onto the transport vehicle.
1. Position the transport vehicle so the aerial platform
will not roll forward after it is loaded.
2. Remove any unnecessary tools, materials, or other
loose objects from the platform.
3. Move the machine to the foot of the loading ramp
with the rear wheels nearest the ramp. Make sure
the machine is centered with the ramps and that the
wheels are straight.
4. Properly stow the aerial platform.
5. Chock the wheels to prevent uncontrolled motion of
the aerial platform.
6. Release foot brakes to allow the machine to move
freely (refer to Figure 10.2).
Forklift Pockets