Snorkel PUSH 10 PRO-sn01-000050+ANSI - Manual (Page 43)

39
Chapter 12 – Troubleshooting
The troubleshooting chart may be used to locate and
eliminate situations where machine operation may be
interrupted. If the problem cannot be corrected with the
action listed, stow the machine and remove it from ser-
vice. Repairs must be made by qualified maintenance
personnel.
Troubleshooting Chart
Symptom Possible Cause Corrective Action
All functions stop working. Motor or pump failure. Manually stow the machine using the
emergency lowering lever.
Low fluid level in reservoir. Check hydraulic fluid level. Add correct
type of fluid if necessary.
Batteries discharged. Recharge batteries.
Electrical system malfunction. Stow the machine and do not operate until
repairs are made.
Platform will not raise or lower
from lower controls.
Control selector switch is in the upper
control position.
Place the switch in the lower control
position.
Emergency stop button is pushed
inward to the off position.
Pull the emergency stop button outward
to the on position.
Emergency lowering lever is not prop-
erly disengaged.
Make sure the lever returns to the normal
operating position.
Platform will not raise and alarm
is sounding.
Machine is not on a level surface. Lower the platform and move to a level
surface.
Platform will not raise, or raises
slower than normal.
Emergency lowering lever not prop-
erly disengaged.
Make sure the lever returns to the normal
operating position.
Platform capacity has been ex-
ceeded.
Remove load from platform. Refer to
platform capacity placard for maximum
capacity.
Low battery charge. Check the battery charge indicator and
recharge the batteries if necessary.
Platform drifts down. Emergency lowering lever not prop-
erly disengaged.
Make sure the lever returns to the normal
operating position.
Hydraulic system malfunction. Stow the machine and do not operate until
repairs are made.
Platform will not lower. Safety prop in place. Stow the safety prop.
Tilt alarm does not work. Platform is not raised more than
4.5’ (1.4 m) for PUSH 8 PRO, 3.2’
(1m) for PUSH 6 PRO and 5.1’ (1.6m)
for PUSH 10 PRO.
Normal operation. The tilt alarm is not
active until the platform is raised more
than 4.5’ (1.4 m) for PUSH 8 PRO, 3.2’
(1m) for PUSH 6 PRO and 5.1’ (1.6m) for
PUSH 10 PRO.
Battery charger does not indi-
cate a reading when charging
batteries.
No source of power. Make sure power source is plugged in
and turned on.
Faulty batteries or charger. Stow the machine and do not operate until
repairs are made.
Hydraulic fluid temperature of
160°F (71°C) or more.
prolonged platform operation. Stop operation until fluid cools.
High pressure fluid return to reservoir
caused by kinked or twisted hose.
Remove the kink or twist from the hose.
Let fluid cool before resuming operation.
Hydraulic system component failure. Stow the machine and do not operate until
repairs are made.
Severe hydraulic leak. Failure of hose, tube, fitting, seal, etc. Stow the machine and do not operate until
repairs are made.