Notice – IKA RC 2 basic User Manual
Page 7
7
Fig. 6
• Filling and draining:
- Before filling the fluid into the bath, open the venting
grid as indicated in following figure.
- Check and make sure that the drain valve is closed (the
stop position in clockwise direction, see Fig. 7).
Note: Please note information in section “Commis-
sioning”.
- Connect the mains plug and turn on the device with
mains switch (2, see Fig. 1).
- The low level warning message appear on the display.
Meanwhile, the bottom LED segment of the lights up
in red color to indicate the low fluid level (see Fig. 8).
- Open the filling lid (5, see Fig. 1) and fill fluid to the
bath.
Stop position
Drain valve
Drain port
Fig. 7
Note: Pay attention to the fluid
level information on the display and
fluid level indicator (see Fig. 8).
Bracket
- To drain the fluid from the bath, connect a hose to the
drain port and turn the drain valve in counter clockwise
direction with a straight screwdriver.
Fig. 9
Red (Low Level)
Red (High Level)
Low Level
High Level
Fig. 8
NOTICE