JLG 500RTS Operator Manual - Manual (Page 20)

SECTION 2 - MACHINE PREPARATION AND INSPECTION
2-6 – JLG Lift – 3120828
37. LP Tank and Bracket (If Equipped) - See Inspection
Note.
38. Steer Spindle, Right Rear (If Equipped) - Evidence
of proper lubrication. See Inspection Note.
39. Drive Wheel and Tire Assembly, Right Rear - Refer
to inflation psi stenciled on frame. See Inspection
Note.
40. Drive Motor, Right Rear - See Inspection Note.
41. Drive Brake, Right Rear - See Inspection Note.
42. Drive Hub, Right Rear - Drive hubs should be one
half full of EPGL SAE 90. See Inspection Note.
43. Safety Prop - Stored securely, no missing parts.
44. Traversing Platform Extension Cylinder (If
Equipped) - See Inspection Note.
45. Engine Installation - Engine oil to full mark on dip-
stick, oil fillercap secure. Muffler/exhaust system
properly secured, no leakage. Air filter assembly
secure, no loose or missing parts, element clean.
Gasoline Engine Only - Radiator cap secure, cool-
ant to correct level.
46. Hydraulic Pump - Pump properly secured, no visi-
ble damage, no evidence of leakage. Hoses and fit-
tings properly secured, no visible damage, no
evidence of leaks.
47. Handrail installation - All railings securely attached,
no damage or missing parts, chains securely
attached.
48. Sizzor Arms and Sliding Wear Pads - Inspect sizzor
arm guards for damage and proper installation.
See Inspection Note.
49. Ladder - See Inspection Note.
50. Lift Cylinder - See Inspection Note.
51. Traversing Platform Extension Cylinder (If
Equipped) - See Inspection Note.
52. Steer/Drive Wheel and Tire Assembly, Right Front -
Refer to inflation psi stenciled on frame. See
Inspection Note.
53. Drive Motor, Right Front (4 Wheel Drive) - See
Inspection Note.
54. Drive Brake, Right Front (4 Wheel Drive) - See
Inspection Note.
55. Drive Hub, Right Front (4 Wheel Drive) - Drive hubs
should be one half full of EPGL SAE 90. See
Inspection Note.
56. Steer Spindle, Right Front - See Inspection Note.
57. High Speed Limit Switch - See Inspection Note.
58. Platform Controls - Properly secured, no loose or
missing parts, no visible damage. Placards secure
and legible, control switches return to neutral. Con-
trol markings legible, manual in manual storage
box.
59. Leveling Jack, Right Front (If Equipped) - See
Inspection Note.
60. Drive and Lift Cutout Switches (If Equipped) - See
Inspection Note.
61. Traversing Platform (If Equipped) - See Inspection
Note.
62. Drive Cutout Switch and High Speed Cutout Switch
- See Inspection Note.
63. Leveling Gauge - See Inspection Note.
64. Traversing Platform Valve (If Equipped) - See
Inspection Note.
65. Platform Assembly - See Inspection Note.
Figure 2-3. Walk-Around Inspection Points (Sheet 2 of 2)