JLG 450AJ Service Manual - Manual (Page 58)

SECTION 2 - PROCEDURES
2-42 – JLG Lift – 3120869
2. Oil all exposed surfaces inside hub (1G).
3. Place internal gear (2) into hub (1G) so that its inter-
nal splines mesh with the external splines of spindle
(1A). Oil internal gear (2).
4. Place thrust washer (11) around spindle (1A) so it
rests on the bottom of the internal gear (2).
5. Stand input shaft (7A) on its splined end. Place one
spacer (7D) onto the smooth end of input shaft (7A).
6. Place one spring (7C) onto the smooth end of input
shaft (7A).
7. Place other spacer (7D) onto the smooth end of
input shaft (7A).
WEAR SAFETY GLASSES DURING THIS STEP, AND BE AWARE
THAT SPRING AND SPACERS, COMPRESSED BY RETAINING
R IN G , M A Y P OP S U D D E N L Y OFF S H A F T I F T H E R IN G I S
RELEASED BEFORE IT IS PROPERLY IN PLACE.