JLG 20VP (3120727) Operator Manual - Manual (Page 26)

SECTION 3 - USER RESPONSIBILITIES & MACHINE CONTROLS
3-4 – JLG Lift – 3120751
2. LIFT ENABLE SWITCH (NEW STYLE) (Fig. 3-3.)
The LIFT ENABLE switch must be pressed and
HELD before UP/DOWN LIFT of the platform is oper-
ational.
3. PLATFORM UP SWITCH (Up Arrow)
When pressed and HELD (in conjunction with the
enable pad switch) this switch raises the platform to
a higher level, when released the upward movement
is stopped.
4. PLATFORM DOWN SWITCH (Down Arrow)
When pressed and HELD (in conjunction with the
enable pad switch) this switch lowers the platform
from a raised position, when released, the down-
ward movement is stopped.
5. EMERGENCY STOP/SHUT-OFF BUTTON
An EMERGENCY STOP (RED) button is provided in
order to immediately stop machine functions from
the platform in the event of an emergency. When
button is depressed, all machine functions will stop.
To re-activate power to the machine, turn button
clockwise to RESET the emergency stop.
6. JOYSTICK DRIVE/STEER CONTROL
(OLD STYLE)
This is a “Point & Go™” control which moves the
platform in the direction which the stick is moved. It
is a fully proportional control, the further from the
center position the joystick is moved, the faster the
machine travels. To activate the control depress the
FUNCTION ENABLE pad switch and within three (3)
seconds, move the joystick in the direction desired.
7. JOYSTICK DRIVE/STEER CONTROL and DRIVE
ENABLE BUTTON
(NEW STYLE)
This is a “Point & Go™” control which moves the
machine in the direction which the stick is moved. It
is a fully proportional control, the further from the
center position the joystick is moved, the faster the
machine travels. To activate the control PRESS and
HOLD the DRIVE ENABLE BUTTON on the top of
the joystick and move the joystick in the direction
desired.
8. VARIABLE SPEED CONTROL
The variable speed control knob can be used to
increase or decrease the maximum drive speed of
the machine. Clockwise rotation increases speed,
counterclockwise decreases speed.
When platform the elevated more than 2 ft. (approx.)
drive speed is automatically cut to 1/4 the speed
from when the platform was completely lowered.
Figure 3-2. Platform Controller. (OLD STYLE)
Figure 3-3. Platform Controller. (NEW STYLE)