JLG 20VP (3120727) Operator Manual - Manual (Page 43)

SECTION 5 - OPTIONAL EQUIPMENT
3120727 – JLG Lift – 5-3
Extending Platform
(Refer to Figure 5-1.)
1. Locate the two (2) platform extend handles, one (1)
located each side of platform on the vertical rails at
the back of the platform.
2. Grasp each extend handle and pull the handle up to
a horizontal position releasing it from the spring
clamp. Face the mast and pull the extend handles to
extend the platform extension forward away from
mast.
3. Slide the platform extension forward until it’s com-
pletely extended, and the extend handles line up
with the spring clamps on the vertical rail at the
opposite end of the platform.
4. Next fold the extend handles down until they lock
into the spring clamps on the vertical rail, this will
lock the platform extension in place.
Retracting Platform
(Refer to Figure 5-1.)
1. To retract the platform grasp the extend handles
now located at the middle of the extended platform
on the vertical rail. Pull up on each handle to a hori-
zontal position to clear the handle spring clamps.
2. Retract the platform extension by standing on the
rear (mast) platform section and pulling the extend
handles toward the mast, (you may need to pull the
handles halfway then turn and push them the rest of
the way to fully retract the platform extension).
3. When both extend handles line up with the handle
spring clamps on the vertical rail at the rear of the
platform, fold the handles down locking them into
the spring clamps.