JLG 4017RS Operator Manual - Manual (Page 106)

Section 5 - Attachments
5-26 31200938
Fork Mounted Hook
Use Fork Mounted Hook Load Chart
To determine maximum capacity, refer to “Telehandler/Attachment/
Fork Capacity” on page 5-4.
Suspend loads in accordance with requirements set forth in Section 1 - General
Safety Practices.
The joystick (1) controls movement of the boom.
The attachment tilt roller switch (2) controls fork mounted hook tilt.
• Push roller switch down to tilt up.
• Push roller switch up to tilt down.
Installation Procedure:
• Ensure carriage is properly installed. Refer to “Attachment Installation” on page 5-10.
• Secure the fork mounted hook to the forks by sliding the fork mounted hook onto the
parent forks and install the retaining pin behind the vertical shank of the fork.
Operation:
• Pallet or lumber forks of an appropriate load rating must be used. Do not use with
cubing or block forks.
• Weight of fork mounted hook and rigging must be included as part of total load being
lifted.
• Do not use fork mounted hook with attachments capable of rotating (i.e. side tilt and
swing carriages) without disabling the rotation features.
OY0640
O 4490 Z
1
2