JLG 4017RS Operator Manual - Manual (Page 54)

Section 3 - Controls and Indicators
3-18 31200938
Attachment Functions
Attachment tilt is controlled by the joystick.
• Move joystick right to tilt down; move joystick left to tilt up.
Auxiliary Hydraulic Functions (if equipped)
Auxiliary Hydraulics roller switch (3) controls function of attachments that require
hydraulic supply for operation. See Section 5 - Attachments for approved attachments
and control instructions.
Continuous Auxiliary Hydraulic Functions (if equipped)
• Depress and release joystick button (4) for continuous operation of hydraulic powered
attachments.
• Set continuous auxiliary hydraulic level (-100% to 100%) using the auxiliary hydraulic
roller switch (3). Push the roller switch up to increase or down to decrease hydraulic
flow.
• Depress and release joystick button (4) again to stop continuous operation.
Outrigger Functions
Joystick button (5) controls both outriggers.
• Press and hold the button; move the joystick forward to lower both outriggers; move
the joystick back to raise both outriggers.
• Press and hold the button; move the joystick left then forward to lower the left
outrigger; move the joystick left then back to raise the left outrigger.
• Press and hold the button; move the joystick right then forward to lower the right
outrigger; move the joystick right then back to raise the right outrigger.
• Outriggers operable with boom at any extension and below 20 degrees or with boom
fully retracted and below 55 degrees.
WARNING
TIP OVER/CRUSH HAZARD. Rapid, jerky operation of controls will cause rapid, jerky
movement of the load. Such movements could cause the load to shift or fall or could
cause the machine to tip over.
WARNING
TIP OVER HAZARD. Outriggers increase stability and load capacity only if they are
used properly. Using outriggers on soft surfaces could cause telehandler to tip over.
Always ensure surface can support telehandler and load.