JLG 4017RS Operator Manual - Manual (Page 30)

Section 2 - Pre-Operation and Inspection
2-6 31200938
2.3 WALK-AROUND INSPECTION
Begin your walk-around inspection at item 1, as noted below. Continue to your right
(counterclockwise when viewed from top) checking each item in sequence.
INSPECTION NOTE: On all components, make sure there are no loose or missing parts, that
they are securely fastened and no visible leaks or excessive wear exists in addition to any
other criteria mentioned. Inspect all structural members including attachment for cracks,
excessive corrosion and other damage.
1. Boom Sections and Lift, Tilt, Extend/Retract, Compensating (Slave) Cylinders -
• Check front, top, side and rear wear pads for presence of grease.
• Pivot pins secure; hydraulic hoses undamaged, not leaking.
OZ3892
16
2
3
1
4
5
6
8
9 11
10
12
13
14
15
17
18
7
19
19
20 20