JLG 660SJ ANSI Service Manual - Manual (Page 103)

SECTION 3 - CHASSIS & TURNTABLE
3120718 – JLG Lift – 3-49
3.14 TILT ALARM SWITCH (MACHINES WITH
EXTERNAL TILT SENSOR)
PERFORM TILT ALARM SWITCH LEVELING PROCEDURE A MINI-
MUM OF EVERY SIX MONTHS TO ENSURE PROPER OPERATION
AND ADJUSTMENT OF SWITCH.
Manual Adjustment
1. Park the machine on a flat, level surface. Ensure
machine is level and tires are filled to rated pressure.
NOTE: Ensure switch mounting bracket is level and securely
attached.
2. Level the base of the indicator by tightening the
three flange nuts through approximately one quarter
of its spring travel. DO NOT ADJUST THE “X” NUT
DURING THE REMAINDER OF THE PROCEDURE.
3. With the electrical connections complete, using bub-
ble level on top of indicator, slowly tighten or loosen
the three flange nuts until indicator is level.
4. Individually push down on one corner at a time;
there should be enough travel to cause the switch to
trip. If the switch does not trip in all three tests, the
flange nuts have been tightened too far. Loosen the
“X” nut and repeat steps (2). through (4).
3.15 SPARK ARRESTER CLEANING
INSTRUCTIONS
1. Remove the cleanout plug in the bottom of spark
arrester (muffler).
2. Without causing deformation (or any type of dam-
age to the spark arrester) repeatedly tap on the
arrester near the cleanout plug. This may be enough
to begin drainage of the spark trap.
3. An industrial vacuum cleaner can do a complete job
at this point.
a. Or, IN A SAFE AREA, start the engine. Then
alternate between low idle and high idle for two
to three minutes.
b. Or, operate the engine as required by the appli-
cation for two to three minutes.
4. Install the cleanout plug.
3.16 ROTARY COUPLING - 600S S/N 75606
TO PRESENT
Figure 3-33. Tilt Switch Adjustment
Table 3-1. Coupling Port Information Table - 2WS
Port
No.
Outlet
Port
Size
Description
Operating
Pressure
PSI (Bar)
Proof
Pressure
PSI (Bar)
1 1 -8 Brake 450 (31) 675 (47)
2 2 -6 2 Speed 4500 (310) 6750 (465)
3 1 -6 Steer 2500 (172) 3750 (259)
4 1 -6 Steer 2500 (172) 3750 (259)
5 2 -6, -16 Drive Reverse 4500 (310) 6750 (465)
6 1 -16 Drive Forward 4500 (310) 6750 (465)
7 3 -8, -6 Case Drain 250 (17) 375 (26)
Table 3-2. Coupling Port Information Table - 4WS
Port
No.
Outlet
Port
Size
Description
Operating
Pressure
PSI (Bar)
Proof
Pressure
PSI (Bar)
1 1 -8 Brake 450 (31) 675 (47)
2 2 -6 2 Speed 4500 (310) 6750 (465)
3 1 -6 Steer 2500 (172) 3750 (259)
4 1 -6 Steer 2500 (172) 3750 (259)
5 2 -6, -16 Drive Reverse 4500 (310) 6750 (465)
6 1 -16 Drive Forward 4500 (310) 6750 (465)
7 3 -8, -6 Case Drain 250 (17) 375 (26)
8 1 -6 Steer 2500 (172) 3750 (259)
9 1 -6 Steer 2500 (172) 3750 (259)