JLG 9MP Service Manual - Manual (Page 37)

SECTION 4 - CONTROL COMPONENTS
3121163 – JLG Lift – 4-7
Tank Removal/Installation
Filter Screen Removal/Installation
Pump Removal/Installation
Pressure Adjust Valve Removal/Installation
Tank - Removal/Installation
• For reassembly reference, place a mark on tank and valve body.
1. Tank Assembly 3. O-Ring Seal (a)
2. Tank Screws (Qty. 4) 4. Reference Mark
Note: (a) Lubricate o-ring with clean hydraulic fluid before sliding
tank over during installation.
Filter Screen - Removal/Installation
• Requires removal of tank assembly.
1. Filter Screen 4. Tube Attach Screw
2. Pump Pick-Up Tube 5. O-Ring
3. Tube Retainer Clip
Note: Tubes shown shortened for illustrative purposes only.
2
4
1
3
2
1
2
3
4
5
Pump - Removal/Installation
• Requires removal of tank assembly and pump pick-up tube.
1. Pump Assembly 3. Motor to Pump Coupler
2. Pump Assembly Screws 4. Pump Shaft Bearing
Pressure Adjust Valve - Removal/Installation
1. Adjust Valve Cap 4. Valve Ball
2. Adjustment Screw 5. Adjust Valve Port
3. Valve Spring
Note: Adjust pressure per specification shown in Section-1 of this
Service Manual.
1
2
3
4
1
2
3
4
5