JLG 9MP Service Manual - Manual (Page 39)

SECTION 4 - CONTROL COMPONENTS
3121163 – JLG Lift – 4-9
Motor Top Cover - Removal/Installation
Motor Components - Removal/Installation
Motor Top Cover - Removal/Installation
1. Motor Top Cover (a) 4. Fiber Spacer
2. Cover Screws (b) 5. Thin Metal Spacer
3. Washers 6. Cover Locating Pin
Notes:
(a) Once cover screws are removed, you may need to
lightly tap around the edge of the top cover to separate it
from the motor housing, or you may pull the entire motor
off of the valve body.
(b) The cover screws are insulated below the head of the screw
in the area of the brush carrier, do not assemble without this
insulating covering.
1
2
3
4
5
6
Pump Motor Components - Removal/Installation
1. Motor Housing 4. Fiber Spacer 7. Lower Rotor Bearing
2. Brush Carrier Screws (3) 5. Thin Metal Spacer 8. Motor to Pump Coupler
3. Brush Carrier Assembly 6. Rotor Assembly 9. Housing Locating Pin
1
2
3
4
5
6
7
8
9