Figure 5-2, Figure 5-2.), Ee figure 5-2.) – JLG 9MP Service Manual User Manual

Page 47

Advertising
background image

SECTION 5 - MAST COMPONENTS

3121163

– JLG Lift –

5-3

1. Sequence Cable Adjust Nut 4. Mast Section - 3 (c)

7. Chain Anchor Plate

10. Threaded Chain End

2. Mast Section - 1 (a)

5. 1 in. (2.54cm) Platform Height (d)

8. Chain Adjust Nut

3. Mast Section - 2 (b)

6. 1/4 in. (6mm) Cable Adjustment (e)

9. Chain Lock (Jam) Nut (f)

Notes:

(a) Mast section fixed.
(b) Mast section raised by lift cylinder.
(c) Mast section lifted by chain, can be adjusted.
(d) Bottom of platform to top of base frame, approximate dimension adjustment.
(e) Mainly adjust to remove slack in cable with 25% spring compression when mast is fully lowered. This adjustment also

depends on mast section 3, platform to base frame adjustment, this adjustment can affect sequence cable adjustment.
Also as cable stretches, more spring compression will be required. If mast section 3 is adjusted properly and sequence
cable cannot be adjusted to remove slack, the sequence cable will need to be replaced due to stretching.

(f)

Apply Loctite #242 at final tightening.

Figure 5-2. Mast Chain and Sequence Cable Adjustment Components. (9MP)

2

3

4

5

1

7

8

10

6

Advertising