JLG G9-43A (9151-4003) Operator Manual - Manual (Page 44)

Attachment Tilt Controls:
Figure 13-4
The carriage tilt cylinder is used to tilt the
swing forks up and down and the carriage
tilt lever controls fork tilt.
The auxiliary control lever is used to swing
the forks to the left and right. Pull lever
back to swing forks right; push lever
forward to swing forks left.
Installation Procedure:
1. Remove carriage/fork combination or other attachment from boom head.
See page 13.1.
2. Install swing forks attachment on boom head.
3. Connect auxiliary hydraulic hoses to swing forks attachment.
Operation:
• Always position forks straight ahead before engaging load.
• To travel with load, keep forks in straight ahead position and lower load
to 1.2m (4 feet) or less above ground allowing for best visibility.
• Inspect supporting surface at delivery point and have it leveled if necessary.
• Use a signal man to assist in positioning the load if necessary.
Slope Piler Carriage
Capacity:
Maximum lift capacity for the slope piler carriage is shown on the attachment
serial number plate. However, maximum lift capacity applies only to certain
areas within boom extension/elevation pattern of handler/slope piler carriage
combination. A separate capacity chart must be used for handlers equipped
with slope piler carriage. Study and understand this chart before attempting to
handle a load with slope piler carriage.
Attachment Tilt Controls:
Figure 13-5
The carriage tilt lever controls carriage tilt.
The auxiliary control lever is used to tilt
slope piler carriage. Push lever forward
to tilt carriage counter-clockwise; pull
lever back to tilt clockwise.
Installation Procedure:
1. Remove carriage/fork combination or other attachment from boom head.
See page 13.1.
2. Install slope piler carriage on boom head.
Operation:
• Connect auxiliary hydraulic hoses to slope piler carriage attachment.
• Approach load with forks centered on load and stop handler.
• Level handler before tilting carriage to engage load.
13.4
WARNING !
PRECAUTIONS
• Read and understand
additional capacity information
under “Capacity” heading.
• Always level forks
(horizontally) before swinging
load to side. Swinging
unlevel forks could result
in load slipping from forks.
• Because the swing forks can
swing the load to the side, it is
especially important that the
handler be level when
handling a load more than
1.2m (four feet) above
ground. See page 11.0.
WARNING !
PRECAUTIONS
• Level handler before tilting
carriage to engage load.
• Always level handler before
lifting a load more than
1.2m (four feet) above
ground. See page 11.0.
WARNING !
Do not handle a load with Slope
Piler Carriage attachment until you
study and understand the “Slope
Piler Carriage Capacity Chart.” If
your handler does not have a
“Slope Piler Carriage Capacity
Chart,” ask your supervisor to get
one before using the attachment.
AUXILIARY
CONTROL LEVER
SWING
LEFT
SWING
RIGHT
AUXILIARY
CONTROL
LEVER
TILT
COUNTER-
CLOCKWISE
TILT
CLOCKWISE