JLG G9-43A (9151-4003) Operator Manual - Manual (Page 54)

38
39
37
31 35 35 31
32
33
30
12 29
9
28
7
8
10
11
6 14
16
17
18
19
20
21 22
23
24
6
6
7
8
10
27 36 27
6
9114-3281 STAY CLEAR OF MOVING PAR TS WHILE ENGINE IS RUNNING. MOVING PAR TS CAN CAUSE SERIOUS INJURY.
13
15
2 2
4
2 2 3
2
5 5 1 4
1 1 1
LUBRICATION & ROUTINE MAINTENANCE
17.1
LUBRICATION NOTICE
• After greasing machine, cycle all functions several times to distribute lubricants. Perform this maintenance procedure
without attachment or forks installed.
• Apply a light coating of engine oil to all linkage pivot points.
• Clean lubrication fittings before lubricating.
• Intervals shown are for normal (8-hour day) usage and conditions. Adjust intervals for abnormal usage and conditions.
• Drain engine and gear cases after operating when oil is hot.
• Check lubricant levels when lubricant is cool. For ease of filling hydraulic reservoir, use a funnel with a hose or flexible tube
for best results.
• Clean filter and air cleaner housing and reusable elements using solvent or diesel fuel. Dry components thoroughly using
lint free cloth.
SYMBOLS
= Lube Fitting
= Other Service
= Service Both Sides
IMPORTANT NOTICE
Be certain to check extend chain
adjustment every 5 weeks or 250
hours and adjust as required. Chain
damage can occur if chain is not
adjusted properly.
F AILURE T O U SE G RADALL
H YDRAULIC F ILTER E LEMENTS
C OULD V OID W ARRANTY
Lubrication Symbols
DF - DIESEL FUEL
EO - ENGINE FUEL
HF - HYDRAULIC FLUID
HM - MOLY LUBE (extreme pressure)
•
Figure 17-2