JLG 150HAX Service Manual User Manual
Page 119
Advertising
SECTION 5 - HYDRAULICS
3120817
– JLG Lift –
5-23
9.
Lift or pry off the first section gear housing. Be care-
ful not to damage machined surfaces. Examine and
replace if necessary.
10.
Inspect all bushings for scoring or discoloration and
replace if necessary. Use a bushing puller as shown
in the tool list to remove bushings.
11.
If the pump is equipped with an outboard bearing,
place the shaft end cover in the vise with the mount-
ing face up. Remove the snap ring with snap ring pli-
ers. If the unit is equipped with a spiral lock retaining
ring, remove with a small screwdriver or awl.
12.
Use a bearing puller to remove the outboard bear-
ing.
Advertising