JLG 150HAX Service Manual User Manual

Page 45

Advertising
background image

SECTION 3 - CHASSIS & TURNTABLE

3120817

– JLG Lift –

3-7

5.

Install retaining ring (19) in groove of input shaft
(20).

6.

Place input shaft into spindle counterbore of hub/
spindle assembly. The action of the disengaged
spring should be checked at this time.

7.

Slide thrust spacer (18) onto input shaft.

BEWARE OF SHARP EDGES OF COUNTERBORE WHILE SEATING
THIS O-RING.

8.

Place o-ring (14) into counterbore of hub/spindle
assembly. Use grease or petroleum jelly to hold o-
ring in place.

9.

Assemble carrier assembly (22) as follows:

a. Press bearing cups (28) into both ends of cluster

gear (27) with large inside diameter facing out.
Use an arbor type press with an adapter tool.

b. Place planet shaft (23) on a flat surface with

large diameter down. Place one bearing cone
(29) over shaft and against shoulder. This should
be a slip fit.

Advertising