JLG 150HAX Service Manual - Manual (Page 120)

SECTION 5 - HYDRAULICS
5-24 – JLG Lift – 3120817
13. Grip the shaft end cover in a vise with the mounting
face down. Remove the double lip seal by inserting
the special seal removal tool into the notch between
the double lip seal and the shaft end cover. Tap the
seal out and discard. Remove and discard all rubber
and polymer seals.
Assembly
1. Stone all machined surfaces with a medium grit car-
borundum stone.
2. If bushings have been removed, deburr the bushing
bores with emery cloth. Rinse parts in solvent. Air
blast all parts and wipe with a clean lint less cloth
before starting assembly.
3. Grip shaft end cover in a vise with the mounting face
down. Examine the plug or plugs to be sure they’re
tightly in place. Replacement is necessary only if
parts are damaged. Remove with a screwdriver.