JLG 150HAX Service Manual User Manual
Page 46
SECTION 3 - CHASSIS & TURNTABLE
3-8
– JLG Lift –
3120817
c. Place cluster gear over planet shaft and onto
bearing cone, with large gear on top.
d. Place another bearing cone (29) over planet
shaft and into cluster gear. This is a slip fit.
e. Slide largest spacer (26) onto planet shaft.
f. Bearings in cluster gear must be seated by
applying 25-50 lbs. (11-23 kg) against them and
rotating cluster gear at the same time. This can
be done by sliding a second spacer (26) over
planet shaft and pushing downward while rotat-
ing the gear.
g. See if retaining ring (25) will fit onto planet shaft
groove. If not, try smaller spacer (26) until retain-
ing ring fits. This will set bearings at 0.000-0.152
mm.
h. Place carrier on edge of a table with one set of
holes hanging over the edge. Side with roll pin
hole should be down.