Battery charging, daily, Battery charging, daily -14 – JLG E300 Operator Manual User Manual
Page 84
SECTION 6 - GENERAL SPECIFICATIONS & OPERATOR MAINTENANCE
6-14
– JLG Lift –
3121252
Battery Charging, Daily
NOTE: To avoid excessive battery charging time, do not allow
batteries to become completely discharged.
To avoid electrolyte overflow, add distilled water to batter-
ies after charging.
When adding water to the battery, fill only to level indi-
cated or 3/8" above separators.
1. Charge batteries at the end of each work day, or when
machine performance is significantly reduced due to
batteries becoming discharged.
2. Charge batteries in accordance with the following proce-
dure:
a. Open battery compartment, and battery charger
compartment covers.
WHEN BATTERY CHARGER IS TO BE USED, CHARGING HARNESS MUST
BE PLUGGED INTO A GROUNDED RECEPTACLE. IF RECEPTACLE IS NOT
GROUNDED AND A MALFUNCTION SHOULD OCCUR, THE MACHINE
COULD CAUSE SERIOUS ELECTRICAL SHOCK.
b. Remove charging harness cable and connect to a
receptacle or the correct voltage.
c. Allow batteries to charge until 100% LED is illumi-
nated.
NOTE: When batteries are completely charged, disconnect
charging harness cable from receptacle. Store charging
harness cable.
d. Ensure battery cables are properly positioned and
are not pinched. Close and secure all compartment
doors.