JLG 110HX Service Manual User Manual
Page 72
Advertising
SECTION 2 - PROCEDURES
2-48
– JLG Lift –
3120864
f. Lower hub onto spindle (30) with large open end
up.
g. Place bearing cone (32) over end of spindle and
into bearing cup.
h. Place bearing shim (34) over end of spindle and
against bearing cone.
EYE PROTECTION SHOULD BE WORN DURING RETAINING RING
INSTALLATION.
i.
Secure retaining ring (35) completely into spin-
dle groove and against bearing shim. Ensure
retaining ring is entirely in groove.
j.
Install retaining ring keeper ring (40) in location
around retaining ring and on bearing shim.
k. With large open end of hub/spindle assembly
facing up, place one spacer washer (42) into
spindle counterbore.
Advertising
This manual is related to the following products: