JLG 110HX Service Manual - Manual (Page 75)

SECTION 2 - PROCEDURES
3120864 – JLG Lift – 2-51
c. Place cluster gear over planet shaft and onto
bearing cone, with large gear on top.
d. Place another bearing cone (29) over planet
shaft and into cluster gear. This is a slip fit.
e. Slide largest spacer (26) onto planet shaft.











f. Bearings in cluster gear must be seated by
applying 25-50 lbs. (11-23 kg) against them and
rotating cluster gear at the same time. This can
be done by sliding a second spacer (26) over
planet shaft and pushing downward while rotat-
ing the gear.
g. See if retaining ring (25) will fit onto planet shaft
groove. If not, try smaller spacer (26) until retain-
ing ring fits. This will set bearings at 0.000-0.152
mm.
h. Place carrier on edge of a table with one set of
holes hanging over the edge. Side with roll pin
hole should be down.