IOGear GWHDMS52MB - Manual (Page 20)

Note: Pressing “Up” or “Down” on receiver side will not initiate switching.
TX
ON INFO OFF
H1 H2
H3 COMP H4
H1 H2
H3 COMP H4
EDID1 EDID2
EDID3 IR
RX
OK
20
4. Power on all connected displays (i.e. HDTV or HD Projector) and source devices (i.e. Cable
box, Blu-ray player, game console).
When the GWHDMS52MB kit is powered on for the first time, the default input is set to
HDMI 1. To select a different source to be displayed, use one of the following options:
Note: When selecting a different source, it will take approximately 5~7 seconds for the
image to appear.
Receiver Source
Switch LEFT/
RIGHT arrow
buttons
Transmitter
Source Switch
UP/DOWN arrow
buttons
Option A
Source button on Transmitter or Receiver
Press the SOURCE button on the top of the
Transmitter or Receiver to cycle through each
source input until the desired input is shown on
the On Screen Display (OSD).
i.e. Pressing SOURCE button on Transmitter
will switch source on Transmitter ONLY.
Option B
Remote Control Source Buttons
When pointing at Transmitter or Receiver:
a. To select a specific source on the
Transmitter, press the corresponding
source button in the area marked TX.
b. To select a specific source on the
Receiver(s), press the corresponding
source button in the area marked RX.
Option C
Remote Control Arrow Buttons
1. When pointing remote at Transmitter:
a. Pressing the UP or DOWN arrow
button will cycle through inputs for the
Transmitter. Once the desired input
is displayed on the OSD, press
OK to
select.
b. Pressing the LEFT or RIGHT arrow
button will cycle through inputs for the
Receiver(s). Once the desired input
is displayed on the OSD, press
OK to
select.
2. When pointing remote at Receiver:
Pressing the LEFT or RIGHT arrow button
will cycle through inputs for the Receiver(s).
Once the desired input is displayed on the
OSD, press OK to select.
OPTION C
OPTION B
a. Transmitter
source buttons
b. Receiver
source buttons