IOGear GWHDMS52MB - Manual (Page 6)

6
CAUTION:
Using the System in the US
• Any changes or modifications not
expressly approved by the grantee of this
device could void the user’s authority to
operate the equipment.
• This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
1. this device may not cause harmful
interference, and
2. this device must accept any
interference received, including
interference that may cause undesired
operation.
Canada, Industry Canada (IC)
Notices
This Class B digital apparatus complies with
Canadian ICES-003 and RSS-210.
Operation is subject to the following two
conditions: (1) this device may not cause
interference, and (2) this device must accept
any interference, including interference that
may cause undesired operation of the device.
Radiation Exposure Statement:
This equipment complies with IC radiation
exposure limits set for an uncontrolled
environment. This equipment should be
installed and operated with minimum distance
20cm between the radiator & your body.
Caution:
1. the device for operation in the band 5150-
5250 MHz is only for indoor use to reduce
the potential for harmful interference to
co-channel mobile satellite systems;
2. High-power radars are allocated as primary
users (i.e. priority users) of the bands
5250-5350 MHz and 5470~5600MHz,
5650~5725MHz and that these radars
could cause interference and/or damage to
LE-LAN devices.
Under Industry Canada regulations, this
radio transmitter may only operate using an
antenna of a type and maximum (or lesser)
gain approved for the transmitter by Industry
Canada. To reduce potential radio interference
to other users, the antenna type and its gain
should be so chosen that the equivalent
isotropically radiated power (e.i.r.p.) is not
more than that necessary for successful
communication.
Radio Frequency (RF) Exposure
Information
The radiated output power of the Wireless
Device is below the Industry Canada (IC) radio
frequency exposure limits. The Wireless Device
should be used in such a manner such that
the potential for human contact during normal
operation is minimized.
RF exposure warning
This equipment must be installed and
operated in accordance with provided
instructions and the antenna(s) used for this
transmitter must be installed to provide a
separation distance of at least 20 cm from
all persons and must not be co-located
or operating in conjunction with any other
antenna or transmitter. End-users and
installers must be provide with antenna
installation instructions and transmitter
operating conditions for satisfying RF
exposure compliance.
This device operates in the 5150 – 5250
MHz frequency range, then restricted in
indoor use only, Outdoor operations in the
5150~5250MHz is prohibit.
This device is slave equipment, the device is
not radar detection and not ad-hoc operation
in the DFS band.