2N BRI Lite/Enterprise v1.7 - Manual (Page 102)

102
2N TELEKOMUNIKACE a.s., www.2n.cz
®
Network List Parameters
%N#0=opx/npx – list of old/new main–prefixes (max 47 chars)
%N#1=pref/dig – list of prefixes/digits–to–end (max 63 chars)
%N#2=pref/dig – pref. list extension (max 63 chars)
%N#3=pref/dig – pref. list extension (max 63 chars)
%N#4=pref/dig – pref. list extension (max 63 chars)
%N#5=pref/dig – pref. list extension (max 63 chars)
%N#6=pref/dig – pref. list extension (max 63 chars)
%N#7=pref/dig – pref. list extension (max 63 chars)
%N#9=netid,max – network id (7 chars), default max digits (0..20)
Routing Parameters
%A##=clip,dial,limit – set autorouting item (ix 0..95)
clip (20), dial(20), limit(0=off,1..99 minutes)
%R##=net,hh:mm/hh:mm/w+–,groups,lim – set lcr–routing item (ix
0..63)
net (1..8), groups = (max 7 chars=1..3,9), 3=any module, 9=bri2
call limit (0=off, 1..99min)
last LCR table line must be empty
; totals
; first m,c,s – inc. minutes,calls,smses
; second m,c,s – out. minutes,calls,smses
; ri,ro – redirected inc,out calls
%TB#=m,c,m,c – init minutes,calls in bri # (0..65535)
%TBALL=m,c,m,c – init minutes,calls in all bris (0..65535)
%TG#=m,c,ri,ro – init minutes,calls,rin,rout in group # (0..65535)
%TGALL=m,c,ri,ro – init minutes,calls,rin,rout in all groups (0..65535)
%TI#=m,c – init minutes,calls in inc.group # (0..65535)
%TIALL=m,c – init minutes,calls in all inc.groups (0..65535)
%T##=1,m,c,s,m,c,s – init minutes,calls,sms in mod ##, sim 1 (0..65535)
%TALL=1,m,c,s,m,c,s – init minutes,calls,sms in all mods, sim 1 (0..65535)
Tracing Commands
AT!RE – Start tracing of error messages active interface.
AT!Lx – Start tracing of LAN & Telnet on layer xx=2 – Layers IP,TCP,Telnet x=3
– Layers TCP, Telnetx=4 – Layer Telnet
AT!Rx – Start tracing of ISDN BRI & GSM on layer xx=1 – Layers 1,2,3,4x=2 –
Layers 2,3,4x=3 – Layers 3,4x=4 – Layer 4
AT!RR – Start tracing (AT!R2) to COM1 interface
AT!RX – Stop tracing (AT!R2) to COM1 interface
SMS Processing
SMS Sending/Receiving Commands
AT!G=A6 – Start low–level controlling for SMS (can run only on one port)
AT!G=55 – Stop low–level controlling on used port