2N BRI Lite/Enterprise v1.7 User Manual
Page 67
67
Generate virtual ring tone – enable/disable generation of the virtual ringing tone
into the VoIP interface.
Call length counting – define whether call minutes or seconds shall be counted.
BTS lock – identify the BTS to which the GSM modules shall log in. Restart the
selected GSM modules to execute the changes.
Network operator code (MCC+MNC) – set the local mobile network provider code
manually. If you do not enter a value, the provider will be selected automatically.
After call relax delay – set the time between the end of the current call and start
of the next call via one and the same GSM/UMTS module. The recommended
value for heavy–traffic installations is 2 seconds!
Add random time – use this auxiliary parameter to add random time in
seconds. Thus, the resultant time is the sum of the two above mentioned
parameters.
Disconnect call
Set the reasons for immediate discontinuation of an outgoing call to GSM/UMTS.
Send CLIP from VoIP to GSM/UMTS
Transfer CLIP to GSM/UMTS – enable/disable the function.
Separating char – define the CDN/CLIP separating character.
Modify (‘–’ remove one digit) – change the CLIP. The ‘–’ character is used for
deleting one character from the left.
GPRS activation
APN string – define the Access Point Name (APN) for GPRS connectivity.
Basic settings
Roaming enabled for network code – international code for the roaming enabled
network. The code consists of the following two numbers:
MCC – Mobile Country Code – national code (Czech Republic – 230, e.g.)
MNC – Mobile Network Code – GSM network code (T–Mobile 01, O202,
Vodafone 03, e.g.)
Hence, the T–Mobile CZ international code is 23001. Leave the field empty to disable
roaming.
Caution
The BTS lock service work with specific GSM modules only (Q55)!
If you set a wrong BTS lock, the selected GSM module(s) will not log in to
GSM.
Caution
The
service must be supported by the
Send CLIP from VoIP to GSM
GSM/UMTS provider's network. Otherwise, the call may be rejected by
GSM/UMTS!