2N VoiceBlue Next v3.5 - Manual (Page 52)

52
2N TELEKOMUNIKACE a.s., www.2n.cz
®
Send CLIP from VoIP to GSM/UMTS
Transfer CLIP to GSM/UMTS – enable/disable the function.
Separating char – the CDN/CLIP separating character.
Modify (" removes one digit) – you can change the CLIP. The "– character is used
for deleting one char from the left.
GPRS activation
APN string define the Access Point Name (APN) for GPRS connectivity. –
Basic settings
Roaming enabled for network code – set the international network identifier for
roaming purposes consisting of the following two codes:
MCC – Mobile Country Code – country code (Czech Republic – 230);
MNC – Mobile Network Code – GSM code (T-Mobile – 01, 0202, Vodafone –
03).
Hence, the international identification code for T-Mobile CZ is 23001. Leave this field
empty to disable roaming.
String Note
<empty> Roaming is disabled
2300 Roaming is disabled (5 digits is the minimum count)
23002 Roaming is enabled for networks with MCC+MNC code 23002
230XX Roaming is enabled for networks with MCC+MNC codes 23000 – 23099
XX001 Roaming is enabled for networks with MCC+MNC codes 00001 – 99001
XXXXX Roaming is enabled for any network
CLIR – fill in this parameter to define whether or not the called subscriber should
be displayed the calling SIM card telephone number. It is recommended that the
telephone number of the SIM card inserted in the GSM module should not be
displayed to the called subscriber to avoid problems with CallBack from GSM.
Caution
The service must be supported by the Send CLIP from VoIP to GSM
GSM/UMTS provider. If not, the provider's network may reject the call!
Note
Check the GSM/UMTS searching priorities on the SIM card using your
mobile phone before enabling roaming.
Caution
Calls via a roaming network may increase you telephone bill!