2N VoiceBlue MAX v1.0 - Manual (Page 45)

45
2N TELEKOMUNIKACE a.s., www.2n.cz
®
FXS interface
Profiles
Line impedance profile – select right impedance of analogue line (according to
region where is the gateway installed)
Ring profile – select right type of ringing profile (pattern, voltage, frequency)
- (according to region where is the gateway installed)
Tone profile – select right type of ringing tone (according to region where is the
gateway installed)
Call ID profile – select right type of Call ID profile (FSK mode) - (according to
region where is the gateway installed)
Functions
Day of deleting statistics (every month) – the day of automatic deletion of call
statistics on the VoIP interface. None = no deletion
Tariff pulse type (metering) – possibility to set-up metering pulses sending
(Disabled/12kHz/16kHz)
FXS line selection for incomming calls – selection of destination FXS line(s) in
case of incomming calls from VoIP or wireless networks
DTMF detector during call enabled – enables/disables DTMF detection during
connected call
Volume settings
Analog to digital gain [dB] – Voice processing settings
Digital to analog gain [dB] – Voice processing settings
Port Modes
This item helps you set each of your gateway ports. The settings are based on
the LCR table including relevant routing/rejecting rules for all incoming and
outgoing calls.
GSM basic parameters
Count of digits dialled from VoIP
Minimum digits from VoIP – minimum count of digits to be dialled into GSM.
Maximum digits from VoIP – maximum count of digits to be dialled into GSM.
Wait for next digit [s] – timeout during which awaits 2N VoiceBlue
®
MAX
further digits dialled from VoIP to GSM.
Calls
Relax timeout [s] – time interval between the end of the last call and the
beginning of the next call via one and the same GSM module (all incoming and
outgoing calls are rejected during this timeout). The recommended value is 2
seconds. Do not change this setting unless absolutely necessary.
Bank holiday list
A list of dates to which the weekend routing mode should be applied in the LCR table.