2N VoiceBlue MAX v1.0 User Manual
Page 51
51
Day of restoring free minutes Day on which the free minute counters are to
be reset automatically. Choose every 24 hours, a day in a month, or a day in a
week for restoring.
Week of restoring free minutes
Define the week in which the free
in month
minute counters are to be reset automatically. This setting is useful when counter
reset takes place on 'every other Friday in month'. Otherwise, leave the 'every'
value.
Caution
We recommend you to set the free minute counter value to
X–5, where X is the count of free minutes obtained from the
GSM/UMTS provider to avoid limit excesses.
The manufacturer is not liable for any additional call costs in
case the GSM/UMTS provider's free minute/SMS limits are
exceeded.
GSM incoming groups
2N VoiceBlue MAX
®
allows you to work with two groups of incoming calls for each of
which you can set variable connection set–up modes.
General settings
Mode – set how the gateway should process incoming GSM calls:
Minimum digits in DTMF – set the minimum count of digits to be required by the
gateway for DTMF dial–in.
Reject incoming calls – all incoming GSM calls are automatically rejected.
Ignore incoming calls – all incoming GSM calls are ignored. The calling
subscriber gets the check ringing tone.
Accept incoming calls + voice message – incoming GSM calls are received
and, if preset so, the DTMF dial–in with a voice welcome note is activated.
Accept incoming calls + dialtone – incoming GSM calls are received and, if
preset so, the DTMF dial–in function with a simulated secondary dialtone is
activated.
CallBack after ring / Reject – in case the CallBack table includes the CLIP, a
CallBack is made. CLIP–less incoming calls are rejected.
CallBack after ring / Ignore – in case the CallBack table includes the CLIP, a
CallBack is made. CLIP–less incoming calls are ignored.
Report to PC + voice message – the GSM gateway sends information on
incoming calls to a PC equipped with the call routing software. The DTMF
dial–in with a voice welcome note can be activated for incoming calls.
Report to PC + dialtone – the GSM gateway sends information on incoming
calls to a PC equipped with the call routing software. The DTMF dial–in with
a simulated secondary dialtone can be activated for incoming calls.
Maximum digits in DTMF – set the minimum count of digits to be accepted by the
gateway for DTMF dial–in.
DTMF dialling timeout [s] – set the time for the GSM gateway to wait for the first
/ next DTMF digits. If you set this parameter to 0, the incoming call is
automatically connected to the numbers included in the
.
List of called numbers
Day of deleting GSM incl. group statistics – define a day in a month on which the
statistics on incoming calls should be deleted.
Prefix before DISA dial–in – enter a numerical prefix to be automatically inserted