ADS-TEC VMT7010/7012/7015 - Manual (Page 33)

VMT7010/VMT7012/VMT7015 32
© ads-tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden-Echterdingen
6.4 USB connections
The USB interfaces are used for connecting peripherals with USB connection. These interfaces comply
with the USB 2.0 standard requirements.
PIN number Signal name
1 VDC
2 D -
3 D +
4 GND
Information:
The device supports a maximum of 8 external USB mass storage devices. If
a USB Flash SSD is installed, a maximum of 7 USB mass storage devices
can be connected.
Information:
The USB interfaces can be individually locked by using the "Lock USB"
software tool.
USB connection in the front panel
One USB interface can be accessed from the front. The interface is located under a plastic cover
underneath the display. The cover has a flap on the right-hand side, which is used for opening. The
plastic cover of the USB interface must be carefully closed after use.
Pos : 30 /D atent ec hni k/Schnitts tell en/PS2/Kombi Buc hs e f ür VMT 60xx @ 2\ mod_1268840073235_6. doc @ 7482 @
Pos : 31 /D atent ec hni k/Schnitts tell en/Netz werkansc hlus s RJ 45/Netz wer kansc hluss RJ 45 für VMT 60xx @ 2 \ mod_1260451135970_6. doc @ 6856 @